casperpo
asked on
Cisco Router 2900 with EHWIC-4ESG (show diag update)
Hi Experts,
I have replaced a EHWIC (by hot swapping) on Cisco 2900 Series (C2900-UNIVERSALK9_NPE-M), Version 15.1(2)T1, RELEASE SOFTWARE (fc1)
Everything seems work fine(Data Transmission Level), EXCEPT it seems to me that the display of the "show diag" EHWIC Serial #, MAC Address are wrongly shown (Cache the old EHWIC info).
Due to a reason I do not want to power cycle the device (Unless I have no choice). Do you know if there are any commands that I can try to sync and update the EHWIC without power cycle it?
Help are highly appreciated.
Regards,
Casper
I have replaced a EHWIC (by hot swapping) on Cisco 2900 Series (C2900-UNIVERSALK9_NPE-M),
Everything seems work fine(Data Transmission Level), EXCEPT it seems to me that the display of the "show diag" EHWIC Serial #, MAC Address are wrongly shown (Cache the old EHWIC info).
Due to a reason I do not want to power cycle the device (Unless I have no choice). Do you know if there are any commands that I can try to sync and update the EHWIC without power cycle it?
Help are highly appreciated.
Regards,
Casper
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.