Solved

Cisco ASA Client Access VPN access and routing

Posted on 2013-05-29
4
436 Views
Last Modified: 2013-06-18
I currently have my Cisco ASA setup with Client Access VPN. Its setup and working correctly I can access all the inside subnets without any issue. My one issue is I am unable to log into the Cisco VPN Access and go over site to site vpn tunnels and unable to ping anything inside. I am able to ping anything inside and the ASA without an issue. I currently have an ASA 5512x
0
Comment
Question by:chris_npion
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 18

Accepted Solution

by:
fgasimzade earned 500 total points
ID: 39206853
You need to add your remote subnet to access-lists and crypto map access list of the vpn site-to-site tunnel and make sure routing is set up correctly
0
 

Author Comment

by:chris_npion
ID: 39210671
I currently have that setup where the subnet of the VPN IP range is configured to be allowed on both sides of the vpn tunnel.
0
 
LVL 18

Expert Comment

by:fgasimzade
ID: 39210681
can you post configs pls
0
 

Author Comment

by:chris_npion
ID: 39257816
No longer an issue. We started using vyatta handling firewall and vpn routing.
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Did you know SD-WANs can improve network connectivity? Check out this webinar to learn how an SD-WAN simplified, one-click tool can help you migrate and manage data in the cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I recently had the displeasure of buying a new firewall at one of the buildings I play Sys Admin at. I had to get a better firewall than the cheap one that I had there since I was reconnecting the main office to the satellite office via point-to-poi…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
In this video we outline the Physical Segments view of NetCrunch network monitor. By following this brief how-to video, you will be able to learn how NetCrunch visualizes your network, how granular is the information collected, as well as where to f…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question