Solved

Cisco 2950 config to simulate multiple internet connections

Posted on 2013-06-04
1
495 Views
Last Modified: 2013-06-06
I am trying to configure a Cisco Catalyst 2950 with multiple VLans so I can simulate the multiple internet connections.  Basically as a test environment for configuring routers/firewalls and vpns between them before taking on site for installation.  
Example -
     Site 1 - IP   123.456.789.2  
                  Mask   255.255.255.248
                  GW  123.456.789.1
     Site 2  - IP   234.567.890.2
                   Mask   255.255.255.248
                   GW  234.567.890.1

     I would like to conf VLan 10 on interface fa0/1 with an ip of 123.456.789.1
   and VLan 20 on interface fa0/2 with an ip of 234.567.890.1
    then allow routing between the vlans.
So if I config ASA1 for Site 1 - it's outside IP will be 123.456.789.2 with a gateway of 123.456.789.1 and plugged into port 1
and config ASA2 for Site 2 - it's outside IP will be 234.567.890.2 with a gateway of 234.567.890.1 and plugged into port 2

How do I configure the catalyst 2950?
0
Comment
Question by:dmfcvi
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 4

Accepted Solution

by:
iammorrison earned 350 total points
ID: 39221046
With the Catalyst on its own, you will not be able to route between vlans, that requires a layer 3 device. The 2950 is only a layer 2 switch so although you can create vlans, the switch cannot route between them
0

Featured Post

Simple, centralized multimedia control

Watch and learn to see how ATEN provided an easy and effective way for three jointly-owned pubs to control the 60 televisions located across their three venues utilizing the ATEN Control System, Modular Matrix Switch and HDBaseT extenders.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Even if you have implemented a Mobile Device Management solution company wide, it is a good idea to make sure you are taking into account all of the major risks to your electronic protected health information (ePHI).
If your business is like most, chances are you still need to maintain a fax infrastructure for your staff. It’s hard to believe that a communication technology that was thriving in the mid-80s could still be an essential part of your team’s modern I…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

726 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question