Solved

Contecting HP procurve switch to 3Com switch.

Posted on 2013-06-07
2
922 Views
Last Modified: 2013-06-07
I am having a spanning tree issue trying to uplink an HP3500y switch to a 3com 5500G-EI switch that is being used as a router and is the root (5500G) on our spanning tree network. When I go to connect the HP3500Y to the 5500G, my 3com 5500G reports that it is receiving different format of BPDU packets! Please change BPDU format configuration.
I understand the concept of spanning tree, but not an expert. What do I need to do on the HP3500Y switch to change its spanning tree format?  All that I have done is enable spanning tree on the switch.
Attached is the error message that I am receiving.
Capture.JPG
0
Comment
Question by:molly22
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 9

Accepted Solution

by:
M Roe earned 500 total points
ID: 39229075
do you have web interface to this..  if so you need to change the state to learning or forwarding under stp link which should show stp bridge and then port
0
 

Author Closing Comment

by:molly22
ID: 39229843
Worked. Thanks.
0

Featured Post

Announcing the Most Valuable Experts of 2016

MVEs are more concerned with the satisfaction of those they help than with the considerable points they can earn. They are the types of people you feel privileged to call colleagues. Join us in honoring this amazing group of Experts.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We recently endured a series of broadcast storms that caused our ISP to shut us down for brief periods of time. After going through a multitude of tests, we determined that the issue was related to Intel NIC drivers on some new HP desktop computers …
This is the first one of a series of articles I’ll be writing to address technical issues that are always referred to as network problems. The network boundaries have changed, therefore having an understanding of how each piece in the network  puzzl…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

690 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question