?
Solved

Solaris - unix

Posted on 2013-06-07
4
Medium Priority
?
660 Views
Last Modified: 2013-06-24
How do I see how  much inode used in solaris 10?

is there any changes between ufs and zfs in term inodes?

Please advise.

Do we check inode per file system in general?  Can someone give me the insides.
0
Comment
Question by:ittechlab
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
4 Comments
 

Author Comment

by:ittechlab
ID: 39229901
what is iPool zPool ?
0
 
LVL 23

Accepted Solution

by:
savone earned 750 total points
ID: 39230309
0
 
LVL 19

Expert Comment

by:jools
ID: 39230831
try df -i or df -ki
0
 
LVL 27

Assisted Solution

by:skullnobrains
skullnobrains earned 750 total points
ID: 39231143
in general "df -i" as mentioned above.

i do not think this would be very relevant in zfs since inodes are allocated on the fly and the number of files or inodes is not limited

df has always had historical problems when coping with zfs and you probably should ignore the reported number of available inodes. the number of used inodes should be accurate, though, at least if you are not using dedup.

----

as a side note this thread should not be located uder "linux". solaris is NOT linux and zfs cannot be ported to the linux kernel without being rewritten completely because of the usual license incompatibilities
0

Featured Post

Get 15 Days FREE Full-Featured Trial

Benefit from a mission critical IT monitoring with Monitis Premium or get it FREE for your entry level monitoring needs.
-Over 200,000 users
-More than 300,000 websites monitored
-Used in 197 countries
-Recommended by 98% of users

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It’s 2016. Password authentication should be dead — or at least close to dying. But, unfortunately, it has not traversed Quagga stage yet. Using password authentication is like laundering hotel guest linens with a washboard — it’s Passé.
Fine Tune your automatic Updates for Ubuntu / Debian
In a previous video, we went over how to export a DynamoDB table into Amazon S3.  In this video, we show how to load the export from S3 into a DynamoDB table.
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
Suggested Courses
Course of the Month9 days, 22 hours left to enroll

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question