agradmin
asked on
Routing change following MPPP
I am adding & bonding a new T1 using MPPP. In this instance the MPPP interface will take on the IP of the original/1st T1
Once the T's are added to the MPPP interface, and the MPPP interface updated with IP I believe I need to update the IP route statement at both ends, eg;
Endpoint1
no ip route 10.100.1.0 255.255.0.0 Serial0/0/0:0
ip route 10.100.1.0 255.255.0.0 Multilink1
and Endpoint2
no ip route 0.0.0.0 0.0.0.0 Serial0/1/0
ip route 0.0.0.0 0.0.0.0 Multilink1
I'd like this to go as smoothly as possible. Does anyone see an issues with that? Is there anything else I need to consider (eg caching)?
All advice is welcomed.
Once the T's are added to the MPPP interface, and the MPPP interface updated with IP I believe I need to update the IP route statement at both ends, eg;
Endpoint1
no ip route 10.100.1.0 255.255.0.0 Serial0/0/0:0
ip route 10.100.1.0 255.255.0.0 Multilink1
and Endpoint2
no ip route 0.0.0.0 0.0.0.0 Serial0/1/0
ip route 0.0.0.0 0.0.0.0 Multilink1
I'd like this to go as smoothly as possible. Does anyone see an issues with that? Is there anything else I need to consider (eg caching)?
All advice is welcomed.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.