seapr
asked on
Disable QoS on Allied telesin switch 610
Hi,
Recently I have enabled QoS on the switch (mls qos enable) and created and configured class and policy maps.
I now would like to disable or remove QoS. Which commands do I need to execute to achieve this. mls qos disable is not a valid command.
Thanks in advance.
Recently I have enabled QoS on the switch (mls qos enable) and created and configured class and policy maps.
I now would like to disable or remove QoS. Which commands do I need to execute to achieve this. mls qos disable is not a valid command.
Thanks in advance.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Did you enter it in configuration mode or in exec mode?
ASKER
I tried both,, in config mode invalid input is under enable instead of mls.
ASKER
Ok I entered the command no mls qos without enable and did not get an error so it seems to have worked.
Thanks
Thanks
ASKER
Command is no mls qos not no mls qos enable
Okay, so it's a bit different from Cisco... :)
Anyway, glad to hear it works!
Anyway, glad to hear it works!
ASKER
I tried the command but it did not work.
no mls qos enable
^
Invalid input detected at`^` marker
Any other suggestions?
Thanks