Solved

CHANGE A TUNNEL CONNECTION TO USE A CELLULAR CONNECTION

Posted on 2013-06-27
3
25 Views
Last Modified: 2016-01-22
I HAVE A REMOTE SITE CONNECTING THROUGH A CISCO 1841 ROUTER VIA DMVPN TUNNEL0 USING THE TUNNEL SOURCE AS THE FASTETHERNET CONNECTION WHICH IS AN ADSL CONNECTION - I WANT TO CREATE ANOTHER TUNNEL INTERFACE ON THE ROUTER - TUNNEL1 (FOR EXAMPLE) AND ENABLE THE CELLULAR 0/0/0 CONNECTION TO BE THE SOURCE FOR TUNNEL0. AT PRESENT THE DEFAULT ROUTE IS  the fastethernet connection. Thus, move the fastethernet connection onto tunnel1 and make the tunnel0 connection go through the cellular0/0/0 interface.
At present the default route is ip nat inside source list acl_nat interface FastEthernet0/0 overload and
ip route 0.0.0.0 0.0.0.0 A.B.C.D
I want to make the default route the cellular interface
0
Comment
Question by:STOPJEET
3 Comments
 
LVL 28

Accepted Solution

by:
asavener earned 500 total points
ID: 39302627
The difficulty, here, is that you can't have the same destination use different interfaces on your router.
0

Featured Post

VMware Disaster Recovery and Data Protection

In this expert guide, you’ll learn about the components of a Modern Data Center. You will use cases for the value-added capabilities of Veeam®, including combining backup and replication for VMware disaster recovery and using replication for data center migration.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I know for anybody starting from Beginner to Expert in Networking knows what OSI model. But this tutorial is for freshers or those who are new to networking world. Why I am putting OSI in such simple and compact manner is because it enables you to k…
Please see preceding article here: http://www.experts-exchange.com/Networking/Operating_Systems/A_11209-Root-Bridge-Election.html Figure 1 After Root Bridge has been elected, then what?..... Let's start by defining a Root Port in la…
Viewers will learn how to properly install and use Secure Shell (SSH) to work on projects or homework remotely. Download Secure Shell: Follow basic installation instructions: Open Secure Shell and use "Quick Connect" to enter credentials includi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

810 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question