Use the command "delete start" from the enable prompt to delete the startup-config file. And then use the "reload" command to reboot the switch.
I see many questions here on Experts Exchange regarding switch port configurations and trunks. This article is meant for beginners in the subject to help to get basic knowledge about Virtual Local Area Network (VLAN (http://en.wikipedia.org/wiki/Vir…
I eventually solved a perplexing problem setting up telnet for a new switch. I installed a new Cisco WS-03560X-24P switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus.
After configuring vlans and trunking, I could no…