Slide show on SD card on Panasonic issues
Hi experts,
Well, this is a little different but very important none the less. I have a 47 inch Panasonic flat screen (one of the few if only that accepts SD cards) that I use to display information about my medical practice. This replaces the hundreds of ugly 8 1/2 by 11 sheets of paper that no one reads.
I set up PowerPoint at 16:9, make the slides, publish them to jpgs, and they are all set. I also go to Google Images and pick out scenery and save them as jpgs. Of course, these all have the same name, say, Slides, therefore, they must all have the same name with (1) at the end before jpg. So, I try to set them up with info slide "Slides (1).jpg" then image "Slides (2).jpg. When I do this and put them in a folder and refresh, they all line up perfectly. There is image slide, then info slide, etc. When I transfer the folder to the SD card and put it into the flat screen, it runs perfectly, but there is always two image slides back to back and two info slides back to back. They run perfectly, except it looks bad. When I remove the SD card and insert into the computer vs USB, they are perfect again. I can run a slide show in the folder.
Is there a way to name them, so they do not do this and run image, info, image, info?
Thank you.
Bert
Well, this is a little different but very important none the less. I have a 47 inch Panasonic flat screen (one of the few if only that accepts SD cards) that I use to display information about my medical practice. This replaces the hundreds of ugly 8 1/2 by 11 sheets of paper that no one reads.
I set up PowerPoint at 16:9, make the slides, publish them to jpgs, and they are all set. I also go to Google Images and pick out scenery and save them as jpgs. Of course, these all have the same name, say, Slides, therefore, they must all have the same name with (1) at the end before jpg. So, I try to set them up with info slide "Slides (1).jpg" then image "Slides (2).jpg. When I do this and put them in a folder and refresh, they all line up perfectly. There is image slide, then info slide, etc. When I transfer the folder to the SD card and put it into the flat screen, it runs perfectly, but there is always two image slides back to back and two info slides back to back. They run perfectly, except it looks bad. When I remove the SD card and insert into the computer vs USB, they are perfect again. I can run a slide show in the folder.
Is there a way to name them, so they do not do this and run image, info, image, info?
Thank you.
Bert
ASKER CERTIFIED SOLUTION
membership
Create a free account to see this answer
Signing up is free and takes 30 seconds. No credit card required.
ASKER
Almost forgot to post back. Worked perfectly. Don't why, but it did.
ASKER