asked on

VNXE 3150 and XenServer/XenCenter

Hello. I am running XenServer 6.1 and managing with XenCenter. I have introduced an EMC VNXE3150 into my environment and am getting this setup. I have created a Generic iSCSI disk as recommended for XenServer with EMC Unisphere. I can see the IQN and Lun number identified and running correctly in Unisphere. I am able to locate the IQN within XenCenter and that registers correctly. However; the Target Lun is where I'm having issues. I can see the disk and Lun number within Unisphere, but XenCenter doesn't see it and gives me the following error:

"Scanning for LUNs on iSCSI filer x.x.x.x

No LUNs were found on x.x.x.x

Check your settings and try again."

Thoughts? What do I need to setup within Unisphere?

Thanks

Rodney Barnhardt

Have you referred to page 74 of the administrator's guide? There is a SMI_S kit that has to be ran to use Storage Link with VNX.

http://support.citrix.com/servlet/KbServlet/download/32307-102-691300/reference.pdf

Storage Link for VNX support is also discussed here: http://support.citrix.com/article/CTX134582

ASKER CERTIFIED SOLUTION

jnordeng

membership

Create a free account to see this answer

Signing up is free and takes 30 seconds. No credit card required.

See answer

Rodney Barnhardt

I am not sure why you are considering this abandoned, unless you are abandoning the question. You were provided with information and indicated that you were going to look into it, but never came back with any additional information.

jnordeng

ASKER

This is unresovled, but considered 'abandoned', will reopen if revisted. Thanks.