• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 722
  • Last Modified:

I require assistance setting up a Cisco SG300-10 switch, please.

Greetings! I had recently purchased a Cisco SG300-10 switch for our facility. It is much more feature rich than I am used to, and I am not a Cisco tech by any means. I was wondering if anyone had any experience with this specific device that could help smooth out the configuration.

I did some testing with this device and have found that I am having difficulty getting the workstations at our satellite office (over the Comcast Metro-E connection) to accept an IP address from our DHCP server here at the main site, even with the DHCP Relay enabled.

I would greatly appreciate any additional advice. I have attached a basic schematic of how we intended the network layout to look like once finished.


  • 2
1 Solution
IT-JesseAuthor Commented:
Please note, the switch is in L2 mode.
UNless your specific with what you want to do the Answers will be a little vague.

The Admin manual can be found here

Here is an example of a switch build

for your DHCP issue you need to configure IP helper on the Switch

Switch#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#int vlan 1
Switch(config-if)#ip helper-address
IT-JesseAuthor Commented:
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

Will You Be GDPR Compliant by 5/28/2018?

GDPR? That's a regulation for the European Union. But, if you collect data from customers or employees within the EU, then you need to know about GDPR and make sure your organization is compliant by May 2018. Check out our preparation checklist to make sure you're on track today!

  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now