AJVCON
asked on
Migrating exchange 2010 to 2013
I have an existing exchange 2010 environment:
KEMP LOAD BALANCER
CAS ARRAY outlook.XXXX.local
XXXEX01 CAS,HT ROLE
XXXEX02 CAS,HT ROLE
XXXEX03 MB ROLE DAG
XXXEX04 MB ROLE DAG
I wan to migrate to exchange 2013 Need step by step guide to help with this process. I want to have the same setup as above with exchange 2013. Not sure if i need to seperate the roles or not. Most i have read is not to seperate the roles anymore. Any suggestions would be greatly appreciated.
Regards
KEMP LOAD BALANCER
CAS ARRAY outlook.XXXX.local
XXXEX01 CAS,HT ROLE
XXXEX02 CAS,HT ROLE
XXXEX03 MB ROLE DAG
XXXEX04 MB ROLE DAG
I wan to migrate to exchange 2013 Need step by step guide to help with this process. I want to have the same setup as above with exchange 2013. Not sure if i need to seperate the roles or not. Most i have read is not to seperate the roles anymore. Any suggestions would be greatly appreciated.
Regards
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.