lofishman
asked on
Cisco Pix 501 Password Reset Anal Question: Setting addresses
Hi all,
When you set the addresses in monitor mode to provide addresses for the interface and TFTP server, are you overwriting any previous address settings, or do these addresses only apply when the router is functioning in monitor mode?
When you set the addresses in monitor mode to provide addresses for the interface and TFTP server, are you overwriting any previous address settings, or do these addresses only apply when the router is functioning in monitor mode?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks Aussie expert!
Then you "overwrite" the IP address set in rommon mode but NOT the ip address set in the configuration when the device is acting in a normal mode.