REIUSA
asked on
Diskpart hangs on a server when you try to run it
I have a server that is running 2008 Ent R2 SP1 and we have a issue where if you open a command prompt and run diskpart it will act like it is running buh then hang befor you get the "DISKPART" prompt.
After a reboot it works fine. It seems like there is something causing a memory leak or some sort of conflict in the system with Diskpart.
Server is fully patched. Any ideas what would cause this or what I can look for when it is hanging that will help determine where the issue is?
After a reboot it works fine. It seems like there is something causing a memory leak or some sort of conflict in the system with Diskpart.
Server is fully patched. Any ideas what would cause this or what I can look for when it is hanging that will help determine where the issue is?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
For the possible problem with the incorrect controller selection how would I check to see if that is a issue? These are HP DL servers.