08519826
asked on
Cisco Aironet 1040 series step-by-step configuration
Hi Experts,
I have a brand new Cisco access point and connected to with a console cable to the unit. How do I configure IP, gateway and web interface, so I can then configure the unit from the web UI. I am not particularly strong with Cisco CLI.
I've gone as far as:
ap.>en
Password:
ap.#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
ap.(config)#interface bvi 1
ap.(config-if)#ip address 192.168.1.250 255.255.255.0
Please post remaining steps.
Thank you.
I have a brand new Cisco access point and connected to with a console cable to the unit. How do I configure IP, gateway and web interface, so I can then configure the unit from the web UI. I am not particularly strong with Cisco CLI.
I've gone as far as:
ap.>en
Password:
ap.#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
ap.(config)#interface bvi 1
ap.(config-if)#ip address 192.168.1.250 255.255.255.0
Please post remaining steps.
Thank you.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks for your help.