goliveuk
asked on
HP System management home page not working
Hello,
On a Proliant ML350 G5 I have a latest version HP System management home page running. However when I start it, it just says: System status ok, and does not show any of the components. Can you please advise how ti fix that ?
On a Proliant ML350 G5 I have a latest version HP System management home page running. However when I start it, it just says: System status ok, and does not show any of the components. Can you please advise how ti fix that ?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Check the data source at the top right hand corner of the homepage, you will see snmp, ensure that this is checked.
Did you see WBEM as well.
YOu should have the option to chose between these two, try each after the other
Regards
Did you see WBEM as well.
YOu should have the option to chose between these two, try each after the other
Regards
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I found the solution my self
ASKER
SNMP services started - they seems configured as the other softwares are running fine - Online diagnostic, arrar conf utility and so on.