Stacking of Cisco Catalyst 6500 Switch

Hi all,

Our network had 2 6513 switches that were configured in a stack. Recently they quit talking to eachother over the stack. The secondary switch was rebooted and it loaded a new config as standalone, and we reconfigured all of its ports.

It was decided to leave the 2 devices unstacked.

Now we are working on the primary 6513. It is still running on it's stacking configuration.
We will need to remove that configuration so that it comes up as a standalone switch like the secondary one did.

Does anyone happen to know which configuration lines I will need to remove from the switch for it to restart as standalone?

I do have an idea that the Module provisioning commands at the end of the attached configuration have something to do with it.

I have attached the running config without the interface and routing configs.

Any help is greatly appreciated!
shanehootonAsked:
Who is Participating?
 
shanehootonAuthor Commented:
Thank you! That worked perfect!

Only issue I had was it wouldn't automatically reboot. and then it wouldn't load the startup configuration, but I got all of that resolved.

Thanks for the link to the document!
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.