Default IP for Dell power Connect 2724 3548

I am remotely troubleshooting a network. There are two Dell switches that I want to access, powerconnect 2724 and 3548. I am hoping the IP address has not been changed from the defaults so that I can access them.

I am trying to find the default username, password and IP address for these two switches. Anyone know that?
Who is Participating?
Fred MarshallConnect With a Mentor PrincipalCommented:
The 3500 series manual:

I don't think it's very clear and some of what I read suggests to me that a password may HAVE to be established from the beginning / user defined.  Hard for me to tell quickly.
Fred MarshallPrincipalCommented:
The default IP address 2724 with login admin no pass
ajdratchAuthor Commented: is not working. I can't be sure it was not changed but it is not showing on the main IP network when I scan it.

The manual was for command line. I Would need to be onsite for that
TMekeelConnect With a Mentor Commented:
You could telnet to the switches, not necessarily have to be onsite for cmd line.
If the main IP schema is not 2.1, then most likely they have been changed from the default.

Try the lower part of the schema, 2.2, 2.3 or the upper, .2.250-254. (Assuming a network)
Most likely they will be there, and not in the DHCP scope.
ajdratchAuthor Commented:
Evidently the IP address has been changed. If not, telnet would have worked.  I'll be onsite in the morning with a cable to connect to it.

Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.