WDS Win7 Issues

Having prepared windows sysprepped image for win7 and imaged via WDS and then added Windows 7 SP1 aftewards, once SP1 installed and rebooted notebooks and PCs run into a 'startup repair' loop, cannot restore either. Why would this be !
LVL 1
discoveranotherAsked:
Who is Participating?
 
VirastaRUC Tech Consultant Commented:
0
 
Raj-GTSystems EngineerCommented:
Were you able to install the pre-SP1 image without any issues?
Did you use the DISM command to add the SP1 to the captured sysprepped wim image?
0
 
discoveranotherAuthor Commented:
Yes the pre-SP1 image went ok.

Have never used the DISM command, how does that work ?
0
 
Raj-GTSystems EngineerCommented:
See links below for instructions on using DISM to service the image.

http://www.faqforge.com/windows/manually-slipstream-sp1-into-windows-7-installer-dvd/

http://superuser.com/questions/249275/slipstream-windows-7-service-pack-1

Once the contents of SP1 has been merged you can start deploying the new wim image using WDS again.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.