Solved

opening wmi and file and print management port services in firewall SCCM 2012

Posted on 2013-10-29
3
523 Views
Last Modified: 2013-11-18
Hi there,
Followed one of the article for installing SCCM2012 where it is advised to open up WMI and file and print services ports on the 'Default Domain Policy'.  Is it safe to open these services for everyone on Default Domain policy?
0
Comment
Question by:amanzoor
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 1

Expert Comment

by:Bjarte Fjelland
ID: 39608651
0
 
LVL 4

Author Comment

by:amanzoor
ID: 39608875
fjebja,
 The question is:
is it safe to open them in 'default domain policy'?
Regards
0
 
LVL 31

Accepted Solution

by:
merowinger earned 500 total points
ID: 39650462
Normally those ports are opened on all Windows Domain Computers by Default in the Firewall.
So i would not deploy and policy....and never do such Settings in the Default Domain policy. Leave the policy as it is
0

Featured Post

Best Practices: Disaster Recovery Testing

Besides backup, any IT division should have a disaster recovery plan. You will find a few tips below relating to the development of such a plan and to what issues one should pay special attention in the course of backup planning.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
VOIP gateways - feedback 23 66
Exchange 2010 mailbox move 7 51
GPS For Commercial Vehicles 10 25
Exchange 2013 will not send or receive 9 17
PRTG Network Monitor lets you monitor your bandwidth usage, so you know who is using up your bandwidth, and what they're using it for.
I had an issue with InstallShield not being able to use Computer Browser service on Windows Server 2012. Here is the solution I found.
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

749 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question