?
Solved

SSG 520 Show Interface Traffic

Posted on 2013-10-30
5
Medium Priority
?
865 Views
Last Modified: 2013-11-16
I have SSG 520 Firewall , i want to know how to get current interface traffic used now , i know the command in cisco is :
show interface fast ethrenet 0/0
which will show me the current traffic on the interface by Kbps.
wait for help ...
0
Comment
Question by:EngAhmedFaris
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 3
  • 2
5 Comments
 
LVL 70

Expert Comment

by:Qlemo
ID: 39610986
A comparable command to see the currently used bandwidth should be
get interface eth0/0  | include "current bw"

Open in new window

0
 

Author Comment

by:EngAhmedFaris
ID: 39611180
Thank you , but all the time it shows 0 kbps , is there any cause for this ?
0
 
LVL 70

Expert Comment

by:Qlemo
ID: 39611226
It's a snapshot, so it might be that you have no traffic at just that second. Or it is the wrong interface. Do you want to view the used bandwidth over time? That's usually done via SNMP then.
0
 

Author Comment

by:EngAhmedFaris
ID: 39611232
all the time i have these readings , is there any way to enable account or statistics .
0
 
LVL 70

Accepted Solution

by:
Qlemo earned 1500 total points
ID: 39611243
a) You can enable traffic count on policies. That won't show the overall bandwidth, though, unless all traffic is flowing using that policy

b) Use SNMP to get periodic snapshots. Tools like Nagios or PRTG are able to show a graph.

c) Run in CLI  get counter flow interface eth0/0  to see accumulated stats since reboot.
0

Featured Post

Four New Appliances. Same Industry-leading Speeds.

But don't take it from us.  The Firebox M370 is Miercom tested and Miercom approved, outperforming its competitors for stateless and stateful traffic throughput scenarios.  Learn more about the M370, M470, M570 and M670 and find the right solution for your organization today!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I recently had the displeasure of buying a new firewall at one of the buildings I play Sys Admin at. I had to get a better firewall than the cheap one that I had there since I was reconnecting the main office to the satellite office via point-to-poi…
Optimal Xbox 360 connectivity requires "OPEN NAT". If you use Juniper Netscreen or SSG firewall products in a home setting, the following steps will allow you get rid of the dreaded warning screen below and achieve the best online gaming environment…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Have you created a query with information for a calendar? ... and then, abra-cadabra, the calendar is done?! I am going to show you how to make that happen. Visualize your data!  ... really see it To use the code to create a calendar from a q…
Suggested Courses

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question