Solved

cisco 1941 3 t1 lines

Posted on 2013-11-09
3
252 Views
Last Modified: 2013-11-10
Hello Experts

Currently have a single point to point line. I have a 1942 router with an hwic dsu t1 interface. Two increase bandwidth I have ordered 3 t1 lines which are going to be combined to increase bandwidth.   Will I need another interface to be able to configure the extra bandwidth?  Not sure how this will work. Any help will be appreciated
0
Comment
Question by:bidgadget
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 12

Accepted Solution

by:
Henk van Achterberg earned 500 total points
ID: 39636855
depends on the technique the ISP is using.

If they are using PPP Multilink then you just need to add this to the dialer interface config:

ppp multilink
0
 

Author Comment

by:bidgadget
ID: 39636979
Thank you. This is a point to point t1 between my two offices. Does that still apply?
0
 
LVL 12

Expert Comment

by:Henk van Achterberg
ID: 39636980
Can you share your current santized config?
0

Featured Post

Guide to Performance: Optimization & Monitoring

Nowadays, monitoring is a mixture of tools, systems, and codes—making it a very complex process. And with this complexity, comes variables for failure. Get DZone’s new Guide to Performance to learn how to proactively find these variables and solve them before a disruption occurs.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

739 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question