Solved

HTTP spelt Traffic in cisco router

Posted on 2013-11-11
3
279 Views
Last Modified: 2013-11-25
Dears in Expert-Exchange

please we need you help in the following case , i need to spilt the HTTP traffic that coming from  subnet 172.16.40.0/24 to go to ADSL line other traffic should go through the lase-line
i tried to use the policy base routing as shown in the attach file but it dosnt work at all
since i need to configure two default roue . and what i used is default route to the lase-line


please help in this case .

the topology in the attach file

also the policy base routing in the router
Drawing1.jpg
Routing-policy.txt
0
Comment
Question by:ziadalshowaiter
  • 2
3 Comments
 
LVL 19

Expert Comment

by:Kash
Comment Utility
don't you need to apply the ACL to interface fa0/0 instead of fa0/1
0
 

Author Comment

by:ziadalshowaiter
Comment Utility
any where , but i required to spilt the HTTP traffic correctly
0
 
LVL 19

Accepted Solution

by:
Kash earned 500 total points
Comment Utility
what you need to bare in mind is to have ACL on the right interface otherwise it is useless.
Try to apply the ACL to fa0/0 interface.
0

Featured Post

Better Security Awareness With Threat Intelligence

See how one of the leading financial services organizations uses Recorded Future as part of a holistic threat intelligence program to promote security awareness and proactively and efficiently identify threats.

Join & Write a Comment

There are no good configuration guides for HP-H3C router to LYNC on the web. :( Big statement, but we havent been able to find one yet. We did find the following document useful, but the information was not enough to use H3C router for use as a L…
Join Greg Farro and Ethan Banks from Packet Pushers (http://packetpushers.net/podcast/podcasts/pq-show-93-smart-network-monitoring-paessler-sponsored/) and Greg Ross from Paessler (https://www.paessler.com/prtg) for a discussion about smart network …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now