HP Procuvre VLAN Question

Hi all,

This is my setup.

HP Procurve 2530 SWITCH on 192.168.1.2

2x VLANs
User VLAN: 20
Public VLAN: 30

Wireless controller with 6 wireless Access points with 2x SSIDs one for each VLAN.

Ports on the switch
1-10 tagged (wireless controller and 6 wireless access points are plugged in here with static addresses from 192.168.1.11 to 17

11-40 Untagged VLAN 20 – user router plugged in with DHCP 192.168.1.x

41-48 Untagged VLAN30 – public router plugged in with DHCP 192.168.2.x


When testing, i cannot connect wirelessly to the user SSID, doesnt get an address from DHCP. This configuration doesnt appear to work, what am I doing wrong?

If I place all the wireless kit on VLAN10 it will probably work fine, but I have been told to set it up as above.
LVL 1
unrealone1Asked:
Who is Participating?
 
unrealone1Connect With a Mentor Author Commented:
Worked out the issue.

By default the controller & Aps sits on Vlan1 , changed all this to vlan20 & it worked .
0
 
Craig BeckCommented:
What wireless controller are you using?

2x VLANs
User VLAN: 20
Public VLAN: 30
If I place all the wireless kit on VLAN10 it will probably work fine
Which is it?  VLAN 20 and 30, or VLAN 10 and ?
0
 
unrealone1Author Commented:
Ruckus zone director 1100, & 7363 APs.

It's van 20 & 30, if I place the ruckus kit on a different IP address range on a seperate vlan it will work fine. This was the config for a previous site.
0
Free Tool: Subnet Calculator

The subnet calculator helps you design networks by taking an IP address and network mask and returning information such as network, broadcast address, and host range.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

 
Craig BeckCommented:
So VLAN 30 works fine?
0
 
unrealone1Author Commented:
I haven't actually tested it. Apologies.
0
 
unrealone1Author Commented:
I have just tried testing the user wifi on vlan20.
0
 
unrealone1Author Commented:
Any thoughts?
0
 
eeRootCommented:
Does each VLAN interface on the HP Procurve switch have an IP Helper address pointing to the DHCP server?    See this PDF
0
 
Craig BeckCommented:
Are clients actually authenticating successfully?
0
 
unrealone1Author Commented:
Thanks
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.