Solved

Cisco 1941 vwic 2 port combine

Posted on 2013-11-15
1
369 Views
Last Modified: 2013-11-15
Hello.  I have a vwic 2 port t1 card.  I was able to configure but now I show 2 serial interfaces.  I need the two t1 lines to act as one.  How would I achieve that?  I know I would use multilink ppp but not sure where I would use that.

Thank you
0
Comment
Question by:bidgadget
1 Comment
 
LVL 12

Accepted Solution

by:
Infamus earned 500 total points
Comment Utility
Hope this helps.

http://www.cisco.com/en/US/docs/ios/qos/configuration/guide/mlppp_over_serial.html

Here is the sample config :

interface Multilink1
 ip address x.x.x.x x.x.x.x
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 ppp multilink
 ppp multilink group 1
 ppp multilink endpoint mac GigabitEthernet0/0
 ppp multilink fragment disable
 
!
interface Serial0/0/0:0
 no ip address
 encapsulation ppp
 ppp multilink
 ppp multilink group 1
 ppp multilink endpoint mac GigabitEthernet0/0
 
!
interface Serial0/0/1:0
 no ip address
 encapsulation ppp
 ppp multilink
 ppp multilink group 1
 ppp multilink endpoint mac GigabitEthernet0/0
0

Featured Post

Why You Should Analyze Threat Actor TTPs

After years of analyzing threat actor behavior, it’s become clear that at any given time there are specific tactics, techniques, and procedures (TTPs) that are particularly prevalent. By analyzing and understanding these TTPs, you can dramatically enhance your security program.

Join & Write a Comment

In a WLAN, anything you broadcast over the air can be intercepted.  By default a wireless network is wide open to all until security is configured. Even when security is configured information can still be intercepted! It is very important that you …
Getting hacked is no longer a matter or "if you get hacked" — the 2016 cyber threat landscape is now titled "when you get hacked." When it happens — will you be proactive, or reactive?
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

772 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

14 Experts available now in Live!

Get 1:1 Help Now