joshuamichaelsanders
asked on
Cisco Clock Line settings
I've been asked by my service provider to set my T1 card to "clock source line". However when I go into the controller and enter the command I don't see it when I do a sh run. Am I doing something wrong?
-J
config t
controller T1 0/0/0
clock source line
-J
config t
controller T1 0/0/0
clock source line
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I don't know if I would say "implied". But given what you're seeing, I would say and "clock source line" is the default.
A subtle difference in terminology, but that's the field we live in, right. :-)
A subtle difference in terminology, but that's the field we live in, right. :-)
ASKER