Solved

How to setup DHCP server for 2 vLan on a Juniper SSG5 firewall

Posted on 2013-11-21
1
1,684 Views
Last Modified: 2013-12-16
I want to setup two subinterfaces on port 0/1 of a Juniper SSG5 firewall. And want to use SSG5 as the DHCP server.
Is it possible to make it release IP for two vLan? From the SSG5 DHCP server GUI, i can not find a way to setup two IP pools and for different vLan id.
Thank you.

vLan1 10.10.10.0/24
gateway 1010.10.1/24
Allow to access internet only.

vLan2 10.10.20.0/24
gateway 10.10.20.1/24
Allow to access both internet and internal network.
0
Comment
Question by:dickchan
1 Comment
 
LVL 18

Accepted Solution

by:
Sanga Collins earned 500 total points
Comment Utility
When you create a sub interface, with or without assigning it a new Vlan tag, you can go to the dhcp section of the web admin and create configure the dhcp server for all your interfaces.
I use this to create a separate network for my VoIP phones and a third network for guest WiFi access. As long as you have interfaces  you should have dhcp options for them.

As far as network access you can then use security policies to define what network has access to different resources.
0

Featured Post

How to run any project with ease

Manage projects of all sizes how you want. Great for personal to-do lists, project milestones, team priorities and launch plans.
- Combine task lists, docs, spreadsheets, and chat in one
- View and edit from mobile/offline
- Cut down on emails

Join & Write a Comment

Suggested Solutions

Do you have a computer or other electronic gear that is attached to a rat nest of cables, or alternatively have your cables all bundled nice at neat?  If so then read this post to sidstep common pitfalls. When I was a student at DeVry University,…
To setup a SonicWALL for policy based routing to be used with the Websense Content Gateway there are several steps that need to be completed. Below is a rough guide for accomplishing this. One thing of note is this guide is intended to assist in the…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

771 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

11 Experts available now in Live!

Get 1:1 Help Now