aasikolo
asked on
MyDlink Camera Won't connect
I am in the process of setting up a MyDlink DCS-930L camera
I reach the step of selecting a wireless connection, Setup finds my WiFi Hot spot, I enter the WiFi hot spot password/number . Setup proceeds, asks if the LED is green, it is, click yes disconnect the Ethernet cable and click ok. It runs for a while and then a message appears that the camera is unable to connect to the internet. It prompts to close and skip registration, OK.
A screen appears that says unable to connect and has a link to change network settings.the settings say that I have a hard wired Ethernet port, which was true for running the setup, However, when I try to change it to DHCP it won't accept the change and gives me the unable to connect the internet message again.
How do I get the setup to accept DHCP so the camera can connect to the internet?
I reach the step of selecting a wireless connection, Setup finds my WiFi Hot spot, I enter the WiFi hot spot password/number . Setup proceeds, asks if the LED is green, it is, click yes disconnect the Ethernet cable and click ok. It runs for a while and then a message appears that the camera is unable to connect to the internet. It prompts to close and skip registration, OK.
A screen appears that says unable to connect and has a link to change network settings.the settings say that I have a hard wired Ethernet port, which was true for running the setup, However, when I try to change it to DHCP it won't accept the change and gives me the unable to connect the internet message again.
How do I get the setup to accept DHCP so the camera can connect to the internet?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Strange though looks like there are two versions of setup wizard installed on my computer?