Solved

VLAN - Created a new vlan but not showing in "Show VLans"

Posted on 2013-11-24
2
305 Views
Last Modified: 2013-11-24
I created the following vlan on one of my cisco WS-C6504-E switches.

 
interface Vlan352
description SecurInfra
ip address 10.14.36.2 255.255.255.0
ip helper-address 172.17.40.40
ip flow ingress
ip flow egress


 
When i do a no shutdown and type "show vlan" to see the list, it is not listed?
This switch is in VTP server mode, so i was able to create it no problem.
am i over looking something?

 
Thanks
0
Comment
Question by:Gamehendge
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 31

Accepted Solution

by:
Gareth Gudger earned 500 total points
ID: 39673663
You also need to do "Vlan352" from the CLI. Then it should show up with a Show VLANs. It's because its not in the VLAN database yet.
0
 

Author Closing Comment

by:Gamehendge
ID: 39673684
Thanks , I created this at L3 but not L2.  That is why it didnt show up on the Show Vlans output.
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

The worst thing when starting a new job is when the previous Network Administrator left behind no documentation. How do you get into the devices? If you've been in this situation or just accidently mistyped your password, this article will hopefully…
Do you have a computer or other electronic gear that is attached to a rat nest of cables, or alternatively have your cables all bundled nice at neat?  If so then read this post to sidstep common pitfalls. When I was a student at DeVry University,…
In a recent question (https://www.experts-exchange.com/questions/29004105/Run-AutoHotkey-script-directly-from-Notepad.html) here at Experts Exchange, a member asked how to run an AutoHotkey script (.AHK) directly from Notepad++ (aka NPP). This video…

738 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question