Coffee101
asked on
Bonded T1s on a Nortel 1002 router
I have a Nortel 1002 with two T1s running into it. The router was configured with two networks running out of each of the two Ethernet ports. Now I just need one network, is it possible to bond the T1 ports or the Ethernet ports so I can the full 3Megs on one network as the 10.1.3.0 network can go away at this point. Posted below if part of the config.
module t1 1
exit t1
module t1 2
exit t1
interface ethernet 0
ip address 10.1.3.1 255.255.255.0
qos
enable mon inbound
exit qos
exit ethernet
interface ethernet 1
ip address 192.168.71.1 255.255.255.0
qos
enable mon inbound
exit qos
exit ethernet
I believe this is the part of the config that would be altered.
thanks in advance.
module t1 1
exit t1
module t1 2
exit t1
interface ethernet 0
ip address 10.1.3.1 255.255.255.0
qos
enable mon inbound
exit qos
exit ethernet
interface ethernet 1
ip address 192.168.71.1 255.255.255.0
qos
enable mon inbound
exit qos
exit ethernet
I believe this is the part of the config that would be altered.
thanks in advance.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.