Solved

My Cisco 2811 ISR w/ 12.4-24.T3 is missing "show bootvar"

Posted on 2013-12-24
2
944 Views
Last Modified: 2013-12-28
sfo-c2811-1#show bootvar
                  ^
% Invalid input detected at '^' marker.


c2811-1#show b?
backhaul-session-manager  backup  bcm560x  beep
bfd                       bgp     bridge   buffers

c2811-1#sho run | i boot
boot-start-marker
boot system flash c2800nm-advipservicesk9-mz.124-24.T8.bin
boot system flash:c2800nm-advipservicesk9-mz.124-24.T3.bin
boot-end-marker
no ip bootp server

...did the command get deprecated?  

On a side note does it matter if there is a ":" between flash and the name of the image file?
0
Comment
Question by:amigan_99
2 Comments
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
Comment Utility
...did the command get deprecated?  
I don't know if deprecated is the right word.  All I know is that it's not a valid command on the 2800's I've run across.

On a side note does it matter if there is a ":" between flash and the name of the image file?
I've never tried to enter a boot system command without it.  I would have expected to command to get rejected. Then again, maybe the IOS is just assuming it's there.
0
 
LVL 1

Author Closing Comment

by:amigan_99
Comment Utility
Well I got everything upgraded in any event.  Thank you!
0

Featured Post

Why You Should Analyze Threat Actor TTPs

After years of analyzing threat actor behavior, it’s become clear that at any given time there are specific tactics, techniques, and procedures (TTPs) that are particularly prevalent. By analyzing and understanding these TTPs, you can dramatically enhance your security program.

Join & Write a Comment

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

771 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now