Solved

ESXi , how to add a IP to a second physical  network adapter

Posted on 2014-01-07
5
3,692 Views
Last Modified: 2014-01-22
I am looking at a brand new install for ESXi 5.5 , I cannot see where in the GUI to set an IP address , there is one for the management network but not for any others

IP addy ?IP?

thanks!!!!IP addy ?IP?
0
Comment
Question by:NAMEWITHELD12
  • 3
  • 2
5 Comments
 
LVL 120

Accepted Solution

by:
Andrew Hancock (VMware vExpert / EE MVE^2) earned 500 total points
ID: 39763275
You add another VMKernel Network Management Portgroup to the vSwitch, and then add an IP Address.

Only a single IP Address per VMKernel.

Do you need two management network IP Addresses ?
0
 
LVL 1

Author Comment

by:NAMEWITHELD12
ID: 39763334
thanks that looks right , I can see if I add it using a Kernal adapter I can give it an IP


I am not sure exactly what this is going to be used for
but I will set ip up as a kernal for vMotion
0
 
LVL 120
ID: 39763368
Yes, would usually use a different, network interface IP Address subnet for vMotion.
0
 
LVL 1

Author Comment

by:NAMEWITHELD12
ID: 39763409
Thanks Andrew !!
0
 
LVL 120
ID: 39763448
No problems.
0

Featured Post

Complete VMware vSphere® ESX(i) & Hyper-V Backup

Capture your entire system, including the host, with patented disk imaging integrated with VMware VADP / Microsoft VSS and RCT. RTOs is as low as 15 seconds with Acronis Active Restore™. You can enjoy unlimited P2V/V2V migrations from any source (even from a different hypervisor)

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In this article, I show you step by step with screenshots to assist you - HOW TO: Deploy and Install the VMware vCenter Server Appliance 6.5 (VCSA 6.5), with some helpful tips along the way.
This article explains how to install and use the NTBackup utility that comes with Windows Server.
This tutorial will walk an individual through the steps necessary to join and promote the first Windows Server 2012 domain controller into an Active Directory environment running on Windows Server 2008. Determine the location of the FSMO roles by lo…
This Micro Tutorial walks you through using a remote console to access a server and install ESXi 5.1. This example is showing remote access and installation using a Dell server. The hypervisor is the very first component of your virtual infrastructu…

749 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question