Solved

Linksys E1500 change DHCP gateway

Posted on 2014-01-14
2
600 Views
Last Modified: 2014-01-14
I have a bank of Cisco 3750-E switches, and they have a gateway address of 10.3.0.1 for all clients.  I have a Linksys E1500 wireless router connected to this switchbank with an IP address of 10.3.0.100 set up for a few mobile clients.  Currently all clients are using static addressing but we want to change the wireless clients to use DHCP.  I enabled DHCP on the router and added DNS addresses and everything is fine except the clients, when connecting wirelessly, are getting the IP address of the router assigned as the gateway.  I need to know if there is a way to pass a different gateway to the clients, or use a routing entry or something to route the traffic to use 10.3.0.1 as the gateway so the wireless clients can communicate with the other clients on the network.
0
Comment
Question by:fallriverelectric
2 Comments
 
LVL 26

Accepted Solution

by:
Soulja earned 500 total points
ID: 39779857
Is the wireless router in AP mode? If so, it should only be a wireless L2 extension of your network. I assume the 10.3.0.100 address is for management correct?

That said if it is in AP mode and not router mode, you should not need to enable dhcp on it, it will just allow dhcp broadcast from your wired network to reach the wireless and vice versa.
0
 

Author Comment

by:fallriverelectric
ID: 39779868
We weren't using DHCP in our wired network, but we reached the same conclusion that it would be easiest to just set up a DHCP server in the network instead of on the router.  Just tried it and it works perfectly.  Thank you!
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
Configuring network clients can be a chore, especially if there are a large number of them or a lot of itinerant users.  DHCP dynamically manages this process, much to the relief of users and administrators alike!
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

778 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question