Solved

Cisco Aironet 600 OfficeExtend Access Point

Posted on 2014-01-16
3
762 Views
Last Modified: 2014-01-17
Hello I have a Cisco Airnonet 600 AP. It stopped working a couple days ago, and now when I power on the device the blue power light blinks constantly and I cannot get it to connect to anything.

I tried resetting it but it just does the same thing. Can anyone help?
0
Comment
Question by:tx_it_guy
  • 2
3 Comments
 
LVL 45

Expert Comment

by:Craig Beck
ID: 39786958
The AP is installing a new software image, which is usually indicated by a blue flashing LED.

Once the software has downloaded the light should go solid blue.

How long do you wait before you reset the AP?
0
 

Author Comment

by:tx_it_guy
ID: 39787516
It has been blinking for several hours now. Don't know what the problem is.
0
 
LVL 45

Accepted Solution

by:
Craig Beck earned 500 total points
ID: 39787958
Can you confirm that the AP is connected to the network correctly, and that you can get internet access by using the cable that the AP connects to if you plug it into a PC or laptop?
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
In this article, I am going to show you how to simulate a multi-site Lab environment on a single Hyper-V host. I use this method successfully in my own lab to simulate three fully routed global AD Sites on a Windows 10 Hyper-V host.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

809 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question