Solved

CUCM 9.1 RTMT call termination code

Posted on 2014-01-16
1
969 Views
Last Modified: 2014-03-10
I am currently having trouble letting callers go out internationally.  It has been working in the past and not sure what has changed. No matter what country is called we get a fast busy signal after the numbers are dialed. It lets us dial all the number with no error. I checked and i cant find anything wrong with our dial peer or call manager.  I am using RTMT and its giving me a code of 27 destination out of order.  We are using cucm 9.1.  I hope this is enough info and i thank you for any help.
0
Comment
Question by:Jobeethemage
1 Comment
 
LVL 20

Accepted Solution

by:
José Méndez earned 500 total points
ID: 39786867
That termination code sounds like CM is trying to communicate with the gateway but fails. Log into the gateway and collect the output after running these debugs:

debug ccapi inout
debug isdn q931
debug ccsip messages
debug h225 asn1
debug h245 asn1
term mon

Be careful not to crash the gateway if you have many many calls.
0

Featured Post

Free learning courses: Active Directory Deep Dive

Get a firm grasp on your IT environment when you learn Active Directory best practices with Veeam! Watch all, or choose any amount, of this three-part webinar series to improve your skills. From the basics to virtualization and backup, we got you covered.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

There are no good configuration guides for HP-H3C router to LYNC on the web. :( Big statement, but we havent been able to find one yet. We did find the following document useful, but the information was not enough to use H3C router for use as a L…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

685 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question