L3 Switch/Route question - HP 5406zl
Posted on 2014-01-17
I'm trying to setup a "test" VLAN on my ProCurve 5406zl. What I wanted to originally do was create an untagged VLAN and then I have a different subnet on that VLAN than the normal network.
So I created:
Then I have a device plugged into the untagged port on the switch on VLAN 33 and that device has an ip of 10.0.0.20
My default vlan is obviously on a different subnet: lets use 192.168.0.1. So my computer, which is on the same physicla switch, but a different vlan is on the 192.168.0.1 network. My default gateway is my firewall.
I added a route from the 192.168.0.1 network to the 10.0.0.0/24 network and told it to use the IP of the default vlan.. 192.168.0.200. After I did that, I can ping the 10.0.0.1 VLAN IP, however I can not get to the 10.0.0.20 device.
Also, when I give the 10.0.0.20 device the 10.0.0.1 gateway, I still can not get out to the internet, or ping another device in the 192.168.0.0/24 subnet.
What am I missing?