unrealone1
asked on
HP Procurve VLAN configuration
HP Procurve switch advice please.
I have a 2610-48 currently in production, which I am replacing with a HP 2530-48G, I may still use the 2610 if I run out of ports.
Current config on 2610
vlan1 - Data - Port2-52untagged - primary
vlan2 - Mitel Phones Port1 untagged, 2-52 tagged
PC's daisy change off the Mitel phones. PLEASE NOTE: When the phones fire up, they say VLAN2, Primary 6. Where is it getting this from?
I want to install the new 2530-48G and amend the vlans to:
VLAN10 - Phones
VLAN20 - Staff Data - Primary
VLAN30 - Student Data
I have wireless access points which have a private ssid which routes to vlan20 and a public ssid which routes through to vlan30.So these APs will be plugged into tagged ports.
Can anyone advise me what the switch config should be?
I have a 2610-48 currently in production, which I am replacing with a HP 2530-48G, I may still use the 2610 if I run out of ports.
Current config on 2610
vlan1 - Data - Port2-52untagged - primary
vlan2 - Mitel Phones Port1 untagged, 2-52 tagged
PC's daisy change off the Mitel phones. PLEASE NOTE: When the phones fire up, they say VLAN2, Primary 6. Where is it getting this from?
I want to install the new 2530-48G and amend the vlans to:
VLAN10 - Phones
VLAN20 - Staff Data - Primary
VLAN30 - Student Data
I have wireless access points which have a private ssid which routes to vlan20 and a public ssid which routes through to vlan30.So these APs will be plugged into tagged ports.
Can anyone advise me what the switch config should be?
The phone is either getting those setting from your DHCP server or they are configured locally on the phone.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks for this.
For the phones do I need to run a voice command set the vlan to voice? I read this somewhere?
For the phones do I need to run a voice command set the vlan to voice? I read this somewhere?
Are the pc's and phones using the same ports?
ASKER
Yes on the wall socket, as well as the switch.
ASKER
Excellent - thanks