I have a vmware esxi 5.5 server setup connected to a dell Equallogic 4000 SAN. I'm attempting to connect to the group ip so I can use SAN HQ to monitor the SAN. The server I'm attempting to connect from is a virtual machine running on the vmware host. The general server network is 192.168.1.X and the san network 192.168.2.X.
Is there something I can do with this to allow a connection to the group ip?
You do not connect SAN HQ to the group IP Address, it's recommended and correct to connect it to the Management IP Address. (iSCSI)
But the SANHQ server must also be on the same LAN as the iSCSI Network
Besides backup, any IT division should have a disaster recovery plan. You will find a few tips below relating to the development of such a plan and to what issues one should pay special attention in the course of backup planning.
Teach the user how to use configure the vCenter Server storage filters
Open vSphere Web Client: Navigate to vCenter Server Advanced Settings: Add the four vCenter Server storage filters: Review the advanced settings: Modify the values of the four v…
This video shows you how to use a vSphere client to connect to your ESX host as the root user.
Demonstrates the basic connection of bypassing certification set up.
Demonstrates how to access the traditional view to begin managing your virtual mac…