WDS Capture not allowing me to see WDS server

Been a while since i configured this.

I have sysprepped my image and trying to capture the image.
I am at the point of image location screen, i given name and location but the server name isnt working..

IDeas?

Thanks
LVL 1
CHI-LTDAsked:
Who is Participating?
 
Sam Simon NasserIT Support ProfessionalCommented:
check the solution here
The first screens are obvious to get through, but the third window is not.

To automatically add a captured image to the WDS server, select the checkbox to connect to the WDS server, enter the server name (no \\), then wait…wait a little more.

When the authentication window opens fill it out with the proper credentials to access the WDS server and target share with write priveleges, hit OK and wait some more.

After authentication, hit Shift-F10 to open a DOS window.

Net use to a directory on the WDS server and close the window.

In the wizard browse to the mapped drive and directory that you wish to capture the image to.

After the capture the WDS server will add the image to its configuration.
You must then open the properties of the image and select the appropriate UNATTEND.XML for that image.
0
 
CHI-LTDAuthor Commented:
got it, required nic driver in capture image.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.