• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 445
  • Last Modified:

Viewing APC 2200 event logs without parachute software previously installed

Hello,

I have a group of servers that were inappropriately shutdown due to a power outage. Unfortunately, on this particular UPS i did  not have any parachute or software installed.

However, I could be wrong, but in the past, I was able to console (COM) to the APC unit and view the logs even though there was no software previously installed. It's as if the events and logs were on the APC unit itself.

This morning I was trying to access a different UPS using the same method, but after installing all the software on the management server which is attached to the APC unit, i was only able to view logs generated since the software was installed.

Again, on the other UPS ( a tried this a while ago) i just installed software and was able to look up data from a few days before i even installed the software.

My question:

Is it possibe to view logs from the APC unit even thought I didn't have any software installed on my management server
0
tobe1424
Asked:
tobe1424
1 Solution
 
pgm554Commented:
The software talks through the signal cable(usb,ether,serial) and log files are written to the disk .

No signal communications ,no log file.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

NEW Internet Security Report Now Available!

WatchGuard’s Threat Lab is a group of dedicated threat researchers committed to helping you stay ahead of the bad guys by providing in-depth analysis of the top security threats to your network.  Check out this quarters report on the threats that shook the industry in Q4 2017.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now