Solved

Telnet to a Radio over Cisco Router

Posted on 2014-03-07
2
321 Views
Last Modified: 2014-03-21
Hi,

PFA of the issue to understand better ..

When we connect to the Ethernet switch of the Router , it is accesble over  telnet 4655.(See scenario 1)

When we move the Radio to the WAN port of the Router , it is not accessible over telnet 4655 (See scenario 2)


FYI :

1. No ACL policies on Router
2. No restrictions configured in Cisco Router
3. from LAN , we are able to get PINg reply to Radio in scenario:2 conditions.
6. Radio is defined telnet access with 4655

Requirement :

By default telnet port is 23. Can we customise Telnet port number to 4655 on Cisco Router to access Radio with telnet 4655.

Regards
Ram
Telnet.jpg
0
Comment
Question by:RAMU CH
2 Comments
 
LVL 34

Accepted Solution

by:
Istvan Kalmar earned 500 total points
ID: 39912632
Hi,

Please provide us the sanitized configs!

Best regards,
Istvan
0
 
LVL 1

Author Closing Comment

by:RAMU CH
ID: 39944623
tks
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Edgemax OS VPN, to Barracuda Link Balancer 7 170
SSL RA VPN 7 109
how to build multiple different ip subnets with one flat subnet 3 74
Stack Switches in IOU  web V22 6 90
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

770 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question