Solved

need to change speed of port 1 on cisco 3750 switch from 1GB back to 100MG

Posted on 2014-03-17
3
1,011 Views
Last Modified: 2014-03-19
last week it was discovered that the port our backup appliance was plugged into was set for 100MB instead of 1GB. Common sense told us to turn it up, and everything was still pinging. I just noticed though that backups are no timing quie often, even though I can still ping th device. I am not too experianced at switches and need to commands to very port 1 is indeed set for 1GB and the command to bring it back to 100MB. Once backups are stable I will start to troubleshoot the issue. I am logged in with putty but confused how to verify and change. I cannot reach my co workers. All advice welcome
0
Comment
Question by:Thor2923
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 6

Accepted Solution

by:
Tim Phillips earned 500 total points
ID: 39935654
To see the set speed:
Switch-A#show interface ge1/1

To set the speed
Switch-A> enable
Switch-A# conf t
Switch-A(conf)# int ge1/1
Switch-A(conf-if)# speed 100
0
 
LVL 1

Author Comment

by:Thor2923
ID: 39936941
THANKS! if you still watching, I have an issue with a remote cisco 2801 router. I may need to reboot. There has not been any config changes to it and I want it runnig like it did yesterday. Do I just enter "reload" I only want to reboot I do not want to loose the saved config
0
 
LVL 6

Expert Comment

by:Tim Phillips
ID: 39937241
Reload will reboot the router without losing changes.  Make sure that the running config is saved to NVRAM: copy run start
0

Featured Post

Simple, centralized multimedia control

Watch and learn to see how ATEN provided an easy and effective way for three jointly-owned pubs to control the 60 televisions located across their three venues utilizing the ATEN Control System, Modular Matrix Switch and HDBaseT extenders.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
Let’s face it: one of the reasons your organization chose a SaaS solution (whether Microsoft Dynamics 365, Netsuite or SAP) is that it is subscription-based. The upkeep is done. Or so you think.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…
Suggested Courses
Course of the Month6 days, 2 hours left to enroll

626 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question