Procurve 2824 and SonicWall Pro 2040

Hello Experts.

I require assistance configuring a VLAN and corresponding routing on a SonicWall Pro firewall.  I have created VLAN 200 on the switch and assigned it IP 192.168.1.253.  I need to get the following working:

- Systems on the 192.168.1.000 network need to reach resources on the 10.0.0.0 255.255.252.0 network
- Systems on the 10.0.0.0 255.255.252.0 network need to reach resources on the 192.168.1.0 255.255.255.0 network.
- Systems on the 192.168.1.000 network need to reach the internet. 10.0.0.0 systems already connect through port X1 on the Sonicwall.

Switch is an HP Procurve 2824.  I need to use ports 20-24 on the HP for the 192 systems.

Any assistance would be appreciated.
swlaurieAsked:
Who is Participating?
 
Aaron TomoskySD-WAN SimplifiedCommented:
Two ways:
On the port from the procurve to the sonicwall, you can allow tagged vlan200 out, and in the sonicwall add a subinterface for vlan200.
OR
Setup x2 on the sonicwall for the vlan200 subnet, but not a vlan, and connect a second cable from the procurve that only allows UNtagged vlan200 packets out.
0
 
Aaron TomoskySD-WAN SimplifiedCommented:
Addition: if you want firewall rules Between these subnets, make them different zones. If not, make them both the LAN zone.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.