Solved

Cisco 1921 No Show DSL Interface Command

Posted on 2014-03-31
2
1,886 Views
Last Modified: 2014-03-31
Hi

I've just upgraded my 1841 to a 1921, the IOS version is
C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M5, RELEASE SOFTWARE (fc2)

On my 1841 I do a "show DSL Interface" and it shows me loads of info about all the dsl interfaces including upload and download sync speeds.

This command is not available on the 1921, does any one know how to show the sync speeds on a 1921?

Thanks

Brasso
0
Comment
Question by:brasso_42
2 Comments
 
LVL 46

Accepted Solution

by:
Craig Beck earned 500 total points
ID: 39966985
It depends on which DSL interface you have installed, but you should try the show controller command instead.

So, for example, if you have a VDSL HWIC installed you could try...

show controller vdsl 0/0/0

Open in new window

0
 
LVL 1

Author Closing Comment

by:brasso_42
ID: 39966991
Thanks so much this worked for me, fyi it was a EHWIC-VA-DSL-A
0

Featured Post

Free Tool: Subnet Calculator

The subnet calculator helps you design networks by taking an IP address and network mask and returning information such as network, broadcast address, and host range.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Cisco ASA 5512 LAN Config 16 107
Configuring Port Access on Cisco ASA 5 42
Site cannot be reached ONLY when connected to modem 18 43
DHCP behind catalyst 3750 POE-48 2 20
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Both in life and business – not all partnerships are created equal. As the demand for cloud services increases, so do the number of self-proclaimed cloud partners. Asking the right questions up front in the partnership, will enable both parties …

730 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question