?
Solved

can we configure linksys dual band router WAG320N AS ACCESS POINT ONLY

Posted on 2014-04-08
4
Medium Priority
?
1,867 Views
Last Modified: 2014-04-14
can we configure linksys dual band router WAG320N AS ACCESS POINT ONLY
PLEASE ADVICE
0
Comment
Question by:sanjeevkmrs
  • 2
  • 2
4 Comments
 
LVL 8

Accepted Solution

by:
EvilKnievel earned 1500 total points
ID: 39988112
That's possible, you have to disable the built-in DHCP server and set a static LAN ip address on the linksys that doesn't conflict with other devices in your network.
After that, you can plug the internet feed in one of the lan ports, the wan port is then no longer used.
Hope this was clear enough.
0
 

Author Comment

by:sanjeevkmrs
ID: 39988295
if I will disable the dhcp from this , can I connect all my wifi devices ?
0
 
LVL 8

Expert Comment

by:EvilKnievel
ID: 39988757
Yes, as long as you have an internet feed with DHCP server connected to one of the lan ports
0
 

Author Closing Comment

by:sanjeevkmrs
ID: 39999772
thanks
0

Featured Post

The new generation of project management tools

With monday.com’s project management tool, you can see what everyone on your team is working in a single glance. Its intuitive dashboards are customizable, so you can create systems that work for you.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

607 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question