Solved

Some commands can not be typed in Cisco firewall

Posted on 2014-04-13
2
200 Views
Last Modified: 2014-04-13
Hi Expert
In Pix 8.02 to setup vpn, I cannot type some commands. Please see below:

I want to type these commands:

tunnel-group admin_vpn general-attributes
tunnel-group admin_vpn ipsec-attributes
tunnel-group 2.2.2.2 type ipsec-l2l

But I cannot type these commands because there are no there commands after I type question marker. Please see:


aa
Can you give me some suggestion ? Thank you.
0
Comment
Question by:EESky
2 Comments
 
LVL 6

Accepted Solution

by:
Hassan Besher earned 500 total points
ID: 39997856
0
 

Author Closing Comment

by:EESky
ID: 39998062
Thank you so much! After i typed "tunnel-group Ad type ipsec-ra" I got it
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Overview The Cisco PIX 501, PIX 506e, ASA 5505 and ASA 5510 (most if not all of this information will be relevant to the PIX 515e but I do not have a working configuration handy to verify the validity) are primarily used within small to medium busi…
From Cisco ASA version 8.3, the Network Address Translation (NAT) configuration has been completely redesigned and it may be helpful to have the syntax configuration for both at a glance. You may as well want to read official Cisco published AS…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

757 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

22 Experts available now in Live!

Get 1:1 Help Now