<div>
Thank you for interesting knowledge.<br />
<br />
I just connected simple d-link unmanaged switch to these workstations and WoL still do not work. Perhaps I need to look on settings on workstations themselves.
</div>


Thank you for interesting knowledge.

I just connected simple d-link unmanaged switch to these workstations and WoL still do not work. Perhaps I need to look on settings on workstations themselves.

<div>
I connected Cisco Catalyst 2960 and WoL start working correctly again. For now I try to understand what's wrong with HP ProCurve configuration. All computers are on the same subnet.
</div>


I connected Cisco Catalyst 2960 and WoL start working correctly again. For now I try to understand what's wrong with HP ProCurve configuration. All computers are on the same subnet.

<div>
<div class="content wysiwyg-content">
I am trying to configure Wake-on-Lan on ProCurve Switch 2610. <br />
<br />
I have 9 workstations connected to ProCurve Switch 2610. ProCurve Switch 2610 was just reset to factory defaults. All ports to which these workstations are connected are up. However I do not see mac-address of workstations connected to these ports.<br />
<br />
I tried to run commands<br />
<br />

<pre><code id="code-10-28413707-1">conf t
IP directed-broadcast
int all
no lacp
write mem</code></pre>
<br />
but these do not help<br />
<br />
I noticed that if I run command<br />
<br />

<pre><code id="code-10-28413707-2">show mac-address 2</code></pre>
<br />
I do not see any mac-address on the port despite port is up.
</div>
</div>


I am trying to configure Wake-on-Lan on ProCurve Switch 2610. 

I have 9 workstations connected to ProCurve Switch 2610. ProCurve Switch 2610 was just reset to factory defaults. All ports to which these workstations are connected are up. However I do not see mac-address of workstations connected to these ports.

I tried to run commands

(CODE)

but these do not help

I noticed that if I run command

(CODE)

I do not see any mac-address on the port despite port is up.

ProCurve Switch 2610 do not see mac-address of workstation witch is powered off, however the port is up.

A switch is a device that filters and forwards packets of data between LAN segments. Switches operate at the data link layer or the network layer of the Open Systems Interconnection (OSI) Reference Model and therefore support any packet protocol. LANs that use switches to join segments are called switched LANs or, in the case of Ethernet networks, switched Ethernet LANs. A hub is a connection point for devices in a network. Hubs are commonly used to connect segments of a LAN. A hub contains multiple ports; when a packet arrives at one port, it is copied to the other ports so that all segments of the LAN can see all packets.

Switches / Hubs

Networking is the process of connecting computing devices, peripherals and terminals together through a system that uses wiring, cabling or radio waves that enable their users to communicate, share information and interact over distances. Often associated are issues regarding operating systems, hardware and equipment, cloud and virtual networking, protocols, architecture, storage and management.