Want to win a PS4? Go Premium and enter to win our High-Tech Treats giveaway. Enter to Win

x
?
Solved

NETGEAR GS752TP VLAN dhcp

Posted on 2014-04-22
1
Medium Priority
?
1,579 Views
Last Modified: 2014-04-23
I have purchased a NETGEAR GS752TP, I have 6 VLANs on it, 3 default and 3 i have created.  
1 for our security system, 1 for wireless and 1 for users.

I can not find out how to set up and assign an IP range to each VLAN only to the entire switch.  Can anyone help me out.

Thanks
Randy
0
Comment
Question by:Randy1279
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 39

Accepted Solution

by:
Aaron Tomosky earned 2000 total points
ID: 40018015
You don't assign an ip range In a layer two switch to vlans. You need a layer 3 device like a router to route between vlans and this is where the subnets are defined.
You might have static routing in this switch, I'm not familiar with the exact model, that may be able to do some vlan routing.

With a switch like this you normally setup all vlans as tagged to your layer 3 device, and set each port to a computer/device as the pvid of the vlan it should be in and untagged for that vlan.
0

Featured Post

Industry Leaders: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
This article will show how Aten was able to supply easy management and control for Artear's video walls and wide range display configurations of their newsroom.
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
In this brief tutorial Pawel from AdRem Software explains how you can quickly find out which services are running on your network, or what are the IP addresses of servers responsible for each service. Software used is freeware NetCrunch Tools (https…

610 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question