Earl Reed
asked on
Visio Dropped Master.GlueTo Shape Not Working
I've attached an example (I saved it in an older format to make it accessible to more users). By the way, rather than including a separate stencil, I just included the Masters that get used in the Document Stencil. I normally use a database too, but I just put a few examples in an array in the VBA code to test with. If you click the "Place Components" button, you will receive 2 errors. If you just click on the "Debug" button in both cases and then right-click on the line below the error that says "Next count" and select "Set Next statement" and then click the "Continue" button at the top, it will allow the code to finish. Once finished, you will see that on the left, the "Filter" Master (labelled F2) got GluedTo the shape it was inserted on. However, on the right hand side, the "Blkhd" Master (labelled "PROCESS OUT") and the "Transition" Master (just a triangle, no label) were both not GluedTo the shape they were inserted on. Any help as to why the one works and the other two do not would be greatly appreciated. Thank You
GlueTo-Test.vsd
GlueTo-Test.vsd
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER